SevernLighting

The Brass LED Bath Wall Lamp runs a slim acrylic diffuser across the full face of a brass back panel, lit from within by an integrated LED. The diffuser is frosted right through, so the whole bar glows as one continuous line with no visible dots or bright spots along its length.

FIXTURE DETAILS

That even line is the point above a mirror: light arrives on your face from the side rather than dropping from overhead, which removes the shadows under the eyes and jaw that a ceiling fixture creates. The brass panel behind stays deliberately plain — no trim, no exposed screws, no visible fittings — so the fixture reads as a single bar against the wall.

Better Together
For a collected, designer-styled room, pair it with matching pieces like the Everett Amber Ripple Wall Sconce.

Measures L 23.6″ in a brass-and-white finish, sold singly or as a set of two, for hardwired wall installation.

SET OF 2

What "Set of 2" Means

Two complete lights, each with its own hardware, shipped together in one order.

☰

Specifications

Design & Material

MaterialBrass, Acrylic

FinishGold

Lampshade ColorWhite

Electrical

Light Source BaseIntegrated LED

Rated VoltageAC 110–120V

WiringHardwired

Installation & Rating

MountingWall

Moisture ResistanceIP20, indoor use

ProcessCutting

Control Method Push-button switch (not dimmable)

Dimensions

Size (cm)	L 60cm x H 12cm
Size (inch)	L 23.6″ x H 3.9″

✦

Where It Fits Best

One continuous line of light — no dots, no bright spots, no shadows under the eyes.

Line illustration of the Linden Brass Vanity Bar Light, a slim brass bar with a continuous frosted glowing line on a round wall plate, mounted above a rectangular vanity mirror and counter

★ Best Fit

Above the Vanity Mirror

Mounted just above the mirror, the frosted bar throws light forward onto your face instead of straight down, so the shadows a ceiling fixture leaves under the eyes and jaw simply are not there. The brass panel reads as one clean line against tile or stone. Where it looks its very best.

Also Shines In

Powder Room

One clean line in a small room.

Dressing Table

Even light for close-up work.

Above Framed Art

A wash across a hallway picture.

Finding Your Fit

At L 23.6″ × H 3.9″ (60 × 12cm), Linden suits a mirror roughly 30–36″ wide — a bar around two thirds of the mirror width keeps the proportions right. Mount it about 3–6″ above the top of the mirror, or roughly 78″ from the floor, so the light clears your head and lands on your face. It is sold singly or as a set of two, one above each mirror on a double vanity.

Good to Know

SizeL 23.6″ × H 3.9″

LightIntegrated LED, no bulb

WiringHardwired, wall mounted

DETAILS MATTER

What Makes It Special

01 Acrylic's Even, Dot-Free Line

The diffuser is frosted through its full thickness, so the LEDs behind it disappear completely — what you see is one continuous line of light rather than a row of bright points showing through.

02 Warm Brass Behind, Soft White in Front

A brass back panel against a white diffuser face: the metal carries the warmth and catches a little of the light at the edges, while the acrylic keeps the glow itself soft and glare-free.

03 Tilts to Aim the Light

The bar pivots up and down on its mount, so the beam can be angled onto the mirror, down toward the counter, or up the wall — set once at installation and adjusted any time after.